WS2811/WS2812 12mm LED pixels (string of 50)

  • Model: RGB5050-WS2811-px
  • Shipping Weight: 0.6lbs
  • 24 Units in Stock
  • Manufactured by: Insomnia Lighting


Add to Cart:
These are some great WS2811 driven LED "pixels". These pixels are fully epoxy sealed and IP68 rated for full immersion (note, the connectors are not waterproof). You'll receive 50 pieces on a string with 2 pin JST SM connectors on each end and separate 5v/gnd connections on each end as well.

Full specs:
12mm "pixels" - 8mm diffused RGB LED with a fully epoxy sealed WS2811 driver board inside
5v operation, 20mA per color (up to 60mA per LED)
2 pin JST SM connector (ground, data) with separate +5v/gnd lines allow you to easily chain these together!
Standard WS2811 protocol, with data sent in standard red, green, blue order
Beautiful 24 bit color!
The male JST SM connector is the input side, with white being data and blue being ground
The separate red/blue wires are for +5v/gnd respectively

If you're new to these LEDs, I have documentation and guides prepared at These pixels work with just about any microcontroller (PIC, Arduino, Propeller, etc) and the WS2811 IC is well documented and widely supported. Please feel free to reach out to me for fast, friendly answers to your questions!

This product was added to our catalog on Sunday 11 September, 2016.

Customers who bought this product also purchased...

Who's Online

There currently are 3 guests online.
Your IP Address is:
Copyright © 2019 Insomnia Lighting. Powered by Zen Cart